download exchange management console 2010 microsoft

The last page of the wizard is needed to enter the provider SMTP relay servers username/password credentials. The other option (use DNS without a relay server) can only be used when you are connected on a fixed IP address and host the webpages yourself. On the next page we switch the configuration to Route email through your provider SMTP relay server (Smarthost in Exchange terms) and add the provider server address. You can build additional specific send connectors for other target addresses, like if there are special routing requirements. The address space „*“ means this send connector is sending out email to any domain on the internet. On the next wizard page we need to specify an address space to be served for this connector. Choose any name (not important for the function) on the first page: And in the Actions pane click on New Send Connector In the middle pane select the Send Connectors tab. Select Organisation Configuration, Hub Transport in the Exchange Management Console. The send connector is used to pipe outgoing emails from Exchange via your providers SMTP relay server to the internet. Configure a send connector for outgoing emails you only have a few email addresses of this domain in your Exchange and need Exchange to send out email to the internet for all other addresses inside this domain please select 'External Relay Domain' instead to tell Exchange to accept internet emails for this domain name and to tell Exchange that it is responsible for only part of the domain.Ģ. Remark: In the rare case where you want to only handle part of a domain in your Exchange, i.e. You can leave it.Ĭhoose New Accepted Domain in the Actions pane.Ĭhoose a name for this domain (not important) and enter your internet domain name (in a format without or as Accepted Domain.Īlso, select Authoritative Domain to tell Exchange to accept internet emails for this domain name and to tell Exchange that it is responsible for the whole domain. There already will be one local domain configured here. In the middle pane select the Accepted Domains tab. Open the Exchange Management Console and select Organization Configuration, Hub Transport. Add your own internet domain to the “Accepted Domains” list (Optional) Check out the ChangeSender Exchange Send-as Outlook Add-inġ.Installing and configuring POPcon, Exchange POP3 Connector.Assign email addresses to individual users in the active directory.Configure a Receive Connector for incoming emails (from POPcon) without Authentication.Configure a Send Connector for outgoing emails.Add your own internet domain to the “Accepted Domains” list.This guide shows the steps necessary to configure a newly installed Exchange 2010 server for receiving email from POPcon or POPcon PRO and for sending out emails to the internet.īasically you need to perform these simple steps: This is the latest version of our Exchange 2010 installation guide (Permanent link):

Download exchange management console 2010 microsoft